Home -> Law Blog Directory -> Personal Injury Law Blogs -> Des Moines Personal Injury Lawyer

Personal Injury Law

: Des Moines Personal Injury Lawyer

Construction Safety and Trial Lawyer Skills: LOTO or Lockout/Tagout Procedures for Electricians

By Steve Lombardi

Yesterday we covered Lockout/Tagout safety rules in a very general way. Today we look at it as lawyers are required. What is the law of Lockout/Tagout?

Lockout/Tagout (LOTO) is addressed in specific standards for the general industry, marine terminals, longshoring, and the construction industry. This page highlights OSHA standards, preambles to final rules (background to final rules), directives (instructions for compliance officers), standard interpretations (official letters of interpretation of the standards), and national consensus standards related to LOTO. Here is the General Duty Clause at 29 CFR 1910 and related subparts.

OSHA

Section 5(a)(1) of the OSH Act, often referred to as the General Duty Clause, requires employers to "furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees". Section 5(a)(2) requires employers to "comply with occupational safety and health standards promulgated under this Act".

General Industry (29 CFR 1910)

• 1910 Subpart J, General environmental controls
  • 1910.147, The control of hazardous energy (lockout/tagout)
    • Appendix A, Typical minimal lockout procedures
• 1910 Subpart R, Special industries
  • 1910.261, Pulp, paper, and paperboard mills [related topic page]
  • 1910.269, Electric power generation, transmission, and distribution [related topic page]
    • Appendix A, Flow charts
• 1910 Subpart S, Electrical
  • 1910.306, Specific purpose equipment and installations
  • 1910.333, Selection and use of work practices

Marine Terminals (29 CFR 1917)

• 1917 Subpart C, Cargo handling gear and equipment
  • 1917.48, Conveyors

Longshoring (29 CFR 1918)

• 1918 Subpart G, Cargo handling gear and equipment other than ship's gear
  • 1918.64, Powered conveyors

Construction Industry (29 CFR 1926)

• 1926 Subpart K, Electrical
  • 1926.417, Lockout and tagging of circuits
• 1926 Subpart Q, Concrete and masonry construction [related topic page]
  • 1926.702, Requirements for equipment and tools

That’s it for today. I’m not going to do all of your work for you. If you need assistance with any case we do act as co-counsel in many cases. Call us at Lombardi Law Firm.

Originally posted at InjuryBoard by Steve Lombardi

Full post as published by Des Moines Personal Injury Lawyer on January 18, 2009 (boomark / email).